OOS - an open operating system for the Rigol Scopes
Not investment advice. Muhabbit scores how much a story may matter, not which way to trade.
Julian Decker has released OOS, an open-source (GPL) replacement operating system for Rigol DHO800/DHO900 oscilloscopes that runs a Linux 6.12 kernel and a Rust-based scope application from the instrument's own SD card alongside the stock firmware, with switching back possible at any time. The software adds deep memory acquisition up to 125 million points, 25 protocol decoders (four simultaneously), eight formula-based math channels, 35 automatic measurements, spectrum, eye-diagram, jitter, power and Bode analysis, plus SCPI, VXI-11, web remote and LXI remote control. OOS leaves the FPGA flash, factory calibration data and uboot/trust/parameter partitions untouched, storing its own self-calibration separately, and ships signed updates with trial boot and automatic rollback. It remains experimental: it has only run on a single DHO924S, some functions have never executed on real hardware, and measurements are not calibrated to any standard. A DHO804 user has also reported a successful run, but the DHO802/DHO812 and the S-model generator and logic-analyser variants are not yet supported. Next to watch is wider hardware validation across DHO800/DHO900 variants and whether the project's experimental sample-clock overclocking and uncalibrated measurements gain acceptance among bench users.
Muhabbit's AI wrote this summary in its own words from Hacker News's report. It can get details wrong, so check the source.
Named in this story
OOS, DHO800/DHO900, Rigol, Linux 6.12, Rust